The measurement on the stock supplied with the QCTP to make the T-nut were 1.750 in. dimension to fit the T-slot on my compound. I'll then need to cut another 0.207 off per side to reach the 1.163 in. to remove to reach the target dimension of 0.216 on this side. FOR SALE ORIGINAL ATLAS CRAFTSMAN MILLING ATTACHMENT VISE JAWS. Going forward I'll be checking the tightness of the set screws after a few cuts to make sure everything stays locked in place. ORIGINAL ATLAS CRAFTSMAN Lathe Milling Attachment Vise Jaws Used - 60.32. Which is why I'm thinking perhaps the vibration is causing the set screws in the milling attachment base to loosen over successive cuts despite being tightened to the point of actually flexing the hex key wrench. This only occurs at the beginning of a cut and after several cuts have already been made. I was specifically warned AGAINST climb milling when I first asked about the milling attachment and followed those instructions to the letter to make sure I didn't damage anything when setting up to use the milling attachment.įor some reason I have yet to pin down to a definite cause, the end mill will bite into the work hard enough to knock the entire setup off axis.
Dial in 0.005 depth of cut (counter clockwise rotation of milling attachment handle) and feed work into cutter slowly. FOR SALE USA MADE ATLAS CRAFTSMAN LATHE MILLING ATTACHMENT VISE JAWS. Tightened up the gibs on the cross feed base that the milling attachment mounts to. ATLAS CRAFTSMAN LATHE Milling Attachment Vise Jaws Usa Made 3/8 X 7/8 X 2 1/2 - 53.30. T-nut behind and below the the end mill feeding toward the operator (counter clockwise rotation of the cross feed handle). 2 - Screw Arbors.That's how i have been running it. Link to pics: Tooling included: Original Manual Craftsman 3-Jaw Chuck Craftsman 4-Jaw Chuck Full set of Change Gears for Threading Micrometer Carriage Stop Milling Cutter Attachment Milling Attachement Atlas Wrench for Toolpost and Tailstock Tailstock Drill Chuck x 2 4 Dead Centers - 2 for Spindle and 2 for Tailstock New in Box Craftsman 5-1/4” Faceplate 2” Clamp Dog 2 - Lathe Dogs - USA Made Original Lantern Toolpost Craftsman Boring Bar Holder set New in Box - Craftsman Tool Post Tool Set Craftsman / Atlas Tool Holders: LH, RH, Threading Tool, Knurling Tool and Cut-Off tool with blade. Any help with pricing would be appreciated. There are 2 movable vise jaws held to the table with.
Standing vertically, the milling attachment has a 2' X 3.75' sliding table with 2 T slots. Remove your toolpost and attach this unit to the cross slide with the 2 T nuts and bolts. I am have having a hard time determining how much to ask. This is a milling attachment for Mini Lathes. It is in excellent shape with lots of tooling most in original boxes. I have decided to sell my Craftsman 6" lathe - (101.21200)
0 kommentar(er)
